Home Improvement

How to Stop a Plumbing Leak Immediately?

Bonus Tip for Temporary Fix

If left neglected, water leaks may do a lot of damage to your property. While you wait for a plumber, you may employ a variety of temporary repairs for leaking pipes, such as epoxy putty or pipe clamps. You may use a slip coupling to make the operation easier if you wish to fix the pipe yourself to bring it up to code.

In any event, a good plumber can replace a failed joint without any trouble. There are many reasons why a pipe joint might fail. A bad weld may be responsible for a leak in the first place, but a broken flange or a leaking joint can be repaired.

Turn off your water supply, regardless of what you’re using, so your pipes don’t leak while you’re working!

How to Stop Plumbing Leaks?

Turning off the water supply is the first method to stop plumbing leaks until you contact a professional plumber. 

It’s not a long-term solution though because once the pipe has been turned off, it can take several days for the water to drain from your home.

Step 1: First of all turn off the water supply of your home, turn the dial clockwise to shut off the water entering your home so that the leak stops and causes no further damage.

Step 2: Turn off all the faucets then turn on one lowest faucet like it can be a basin or sink or garden hose and let water flow until your pipe gets empty.

Step 3: Once all the water is drain, dry the leaking area of the pipe. You can also clean it with dry clean clothes to make sure it is completely drained.

If your water heater has an electric heating element. You need to open the control panel and shut off the power. If your water heater has a gas-fired furnace, turn off the pilot light. For the best results, remove any appliances or items that may be in the way of the leak.

BONUS TIP: Using Epoxy Putty for a Temporary Fix

Step 1: Use proper PPE as a first step. Putting on latex or nitrile gloves may harm your skin. Epoxy putty heats up while you’re working. Sometimes it may cause pain on your skin.

Step 2: Mix plumbing epoxy putty properly tears off a piece of an epoxy plumber. It is the same size as the leaking region of the pipe. To blend the putty into a single uniform color and make it pliable, knead the epoxy in your palms. Place the epoxy over the hole or leaking area based on the pipe and press it down gently.

Step 3: Let the putty set for 5-10 minutes before turning your water on, leave the putty for minutes, And Once the epoxy sets, you can turn your water back on.  It is a temporary method for permanent or to replace you can call a licensed plumber as soon as possible.

What if the leak is still there?

If the leaking problem still persists, it is best to get in touch with a professional plumber for an advanced water leak detection service.

Related Articles

Back to top button